Virtual TapeServer 6.03.42 Operations and Administration Guide

40 | Configuring EMS Communication
ems_notify_wait_
timeout
Specifies the number of seconds
to allow the host to process
commands before VTS expects
to prompt for another command.
Typically, this should be 2-3
seconds but it causes no harm to
allow more time for the host.
Default value: 20
Integer No
ems_notify_logout_
timeout
Specifies the number of seconds
to wait after issuing the
LOGOUT command and before
closing the socket connection.
Default value: 3
Integer No
ems_keep_alive Enables VTS to send periodic
EMS messages to the host so
that the Telnet session does not
time out. When enabled, EMS
filtering on the host can be
increased because VTS stays
alive.
Default value: NO
YES or NO No
ems_response_
timeout or
ems_response_
timeout_NSserver
Specifies the timeout value (in
seconds) used to wait for each
response during the EMS Telnet
login process. Note that the
_NSserver suffix is optional
and, when omitted, this
parameter applies to all
processing (but is overridden by
_NSserver specifications).
Default value: 5
Integer No
ems_hostport_
NSserver
Specifies the target Telnet port.
The default value is 23, which is
the default value on the
NonStop server.
You can specify _ANYSYS
instead of _NSserver.
Default value: 23 (set for
_ANYSYS)
Integer No
Parameter Description Values Required