Virtual TapeServer 6.04.01 Installation Guide

98 | Enabling Instant DR and AutoCopy
c. At the [root@site default]# prompt, enter startx. This starts the VTS operating
system UI.
d. From the operating system UI, click the Linux Start button at the bottom left-hand
side of the window.
e. Select System →Network Device Control from pop-up list. The Network Device
Control window is displayed.
f. Select eth1 and click Configure. The Network Configuration window is displayed:
g. Double-click eth1.
h. Select Activate device when computer starts.
i. Select Statically set IP Addresses.
j. Provide the IP address, subnet mask, and default gateway. In this example, the
boston VTS server is configured with IP address 10.10.2.145, subnet mask
255.255.255.0, and default gateway 10.10.2.1.
Note eth1 must have a different IP subnet address then eth0.
k. Click OK.