Virtual TapeServer 6.04.01 Installation Guide

100 | Enabling Instant DR and AutoCopy
e. Repeat these steps for each VTS site.
In this example, after completing these steps for all VTS servers, the Hosts tab looks
like this:
f. Select File→Save.
g. Click OK.
h. Close the Network Configuration window.
i. Select eth1.
j. Click Deactivate.
k. Click Activate.
l. Select eth0.
m. Click Deactivate.
n. Click Activate.
o. From the operating system GUI, select the Screen icon located at the bottom left-hand
side of the window. A command prompt window is displayed.