Virtual TapeServer 6.04.01 Installation Guide

154 | Hardware Information for Legacy Installations
The following order of SCSI card removal must be followed:
a. Remove the SCSI card in slot 3 and install the first Fibre Channel card in slot 3.
b. Remove the SCSI card in slot 4 and install the second Fibre Channel card in slot 4, if
necessary.
c. Remove the SCSI card in slot 2 and install the third Fibre Channel card in slot 2, if
necessary.
d. Remove the SCSI card in slot 1 and install the fourth Fibre Channel card in slot 1, if
necessary.
e. Remove the SCSI card in slot 7 and install the fifth Fibre Channel card in slot 7, if
necessary.
f. Remove the SCSI card in slot 8 and install the sixth Fibre Channel card in slot 8, if
necessary.
Here is a snapshot of the SCSI card after it is removed:
7. After you install all of the Fibre Channel upgrade cards in the appropriate slots, make
sure the blue clips are firmly seated and locked in place on each slot. Then, re-install the
shipping bracket and make sure the pull tab is secure.
8. Place the top cover back in place and secure it. Slide the HP DL585 ProLiant server back
into the rack and secure the two quick-disconnect screws on the front panel.
9. From the rear of the HP ProLiant DL585 server, reconnect any remaining SCSI cables to
the same ports where they were originally connected, if necessary. Because you removed
one or more SCSI cards, you will have several extra, unused SCSI cables. Reconnect the
power cords.
Now, continue with step 4 on page 143 and step 5 on page page 143.