Virtual TapeServer 6.04.01 Installation Guide

82 | Configuring EMS Communication
ems_response_
timeout
Specifies the timeout value (in
seconds) used to wait for each
response during the EMS Telnet
login process.
Note that you can specify the
ems_response_timeout_
NSserver instead of or in
addition to this parameter. If
ems_response_timeout_
NSserver is specified, its value
overrides the value of this
parameter for the specified host.
See the next step for more
information about ems_
response_timeout_NSserver.
Default value: 5
Integer No
ems_mount_delay Specifies the minimum number
of seconds that must elapse
after VTS receives a mount
request. The mount is queued
and the virtual tape is locked for
mounting or a restore by a
backup management
application.
Integer No
ems_InterSystem
Communication_
hosts
Specifies a list of hostnames or
IP addresses of other VTS
systems with which VTS will
coordinate mount processing.
This parameter is required only
if GFS is implemented. It is
primarily used to cancel
pending mounts on other VTS
systems that have simultaneous
access to the same vaults
mounted by GFS.
List of host
names or IP
addresses
separated by
spaces
No
Parameter Description Values Required