Virtual TapeServer 6.04.01 Installation Guide

86 | Configuring EMS Communication
ems_virtdevs_
NSserver
Specifies the list of virtual tape
drives known to the NonStop
server that correspond to the
list specified by
ems_hostdevs_NSserver. If
this entry is omitted, VTS uses
the same names listed for the
host. If specified, there must be
the same number of virtual tape
names as host tape names.
There is a one-to-one
correspondence.
List of
virtual tape
drives
separated by
spaces
Yes
ems_notify_wait_
timeout_NSserver
Specifies the number of seconds
to allow the host to process
commands before VTS expects
to prompt for another command.
Typically, this should be 2-3
seconds but it causes no harm to
allow more time for the host.
Default value: 20
Integer No
ems_notify_logout_
timeout_NSserver
Specifies the number of seconds
to wait after issuing the
LOGOUT command and before
closing the socket connection.
Default value: 3
Integer No
ems_response_
timeout_NSserver
Specifies the timeout value (in
seconds) used to wait for each
response during the EMS Telnet
login process.
Default value: 5
Integer No
Parameter Description Values Required