Virtual TapeServer 6.04.01 Operations and Administration Guide

42 | Configuring EMS Communication
ems_notify_enable Enables EMS messages to be
generated for notifications.
Default value: NO
YES or NO No
ems_notification_
enable
Enables VTS to send
notification messages back to
the NonStop host from EMS
messages.
Default value: NO
YES or NO No
ems_notification_
level
Enables EMS to acknowledge
certain EMS messages and
generate completion status
(success or failure) messages.
This parameter is synonymous
with the ems_hsm_
backup_notification
parameter set for migration
configuration. Set this
parameter to one or more of the
values, separated by spaces. If
the notification level of the
event matches one of the words,
the event log message is
forwarded to the EMS host. If
you set this parameter to
NONE, no event log messages
are forwarded to the host.
Default value: ERROR
CRITICAL
ALL, INFO,
WARNING,
ERROR,
CRITICAL,
or NONE
No
ems_notify_
hostnames
Specifies the host systems that
VTS will notify. This parameter
defaults to the value of
ems_hostnames if it is not
specified in the configuration
file.
Default value: YES
List of
hostnames
or IP
addresses
separated by
spaces
No
Parameter Description Values Required