Virtual TapeServer 6.04.01 Operations and Administration Guide

Configuring EMS Communication | 43
ems_keep_alive Specifies the number of seconds
between periodic EMS messages
that are sent from VTS to the
host so that the Telnet session
does not time out. When set,
EMS filtering on the host can be
increased because the Telnet
connection between the VTS
server and the NonStop host
stays alive. If omitted or set to 0,
keep-alive messaging is
disabled.
Integer No
ems_notify_wait_
timeout
Specifies the number of seconds
to allow the host to process
commands before VTS expects
to prompt for another command.
Typically, this should be 2-3
seconds but it causes no harm to
allow more time for the host.
You can specify ems_notify_
wait_timeout_NSserver
instead of or in addition to this
parameter. If ems_notify_
wait_timeout_NSserver is
specified, its value overrides the
value of this parameter for the
specified host. See the next step
for more information about
ems_notify_wait_timeout_
NSserver.
Default value: 20
Integer No
ems_notify_logout_
timeout
Specifies the number of seconds
to wait after issuing the
LOGOUT command and before
closing the socket connection.
Note that you can specify the
ems_notify_logout_timeout_
NSserver instead of or in
addition to this parameter. If
ems_notify_logout_timeout_
NSserver is specified, its value
overrides the value of this
parameter for the specified host.
See the next step for more
information about ems_notify_
logout_timeout_NSserver.
Default value: 3
Integer No
Parameter Description Values Required