Virtual TapeServer 6.04.01 Operations and Administration Guide

Configuring EMS Communication | 47
d. For each hostname specified by ems_hostnames, you can add the following host-
specific EMS parameters at the bottom of the file that is displayed.
These parameters end with _NSserver, where NSserver is one of those listed for
ems_hostnames. However, you can also specify _ANYSYS for parameters pertaining
to all hosts. If the same parameter is specified that end with _NSserver, the
corresponding _ANYSYS parameter is overridden.
ems_login_
successful_type
Defines a command string to
send after successful login. See
ems_service_prompt_type
for an explanation of type.
Default values:
• for _TYPE:TACL:
/Last Logon:/
• for _TYPE:TACLS:
/Last Logon:/
• for _TYPE:XYGATE:
/Last Logon:/
• for _TYPE:SAFEGUARD:
/Last Logon:/
Expression
or null
No
Parameter Description Values Required
ems_hostaddr_
NSserver
Specifies the Telnet target for
each host.
An IP
address or
DNS name
Yes
ems_hostport_
NSserver
Specifies the target Telnet port.
Default value: 23 (set for
_ANYSYS)
Integer No
ems_hostdevs_
NSserver
Specifies the list of tape device
names configured on the
NonStop server that are
connected to VTS.
List of tape
device
names
separated by
spaces
Yes
Parameter Description Values Required