Virtual TapeServer 6.04.02 for NonStop Servers Quick Setup Guide

Virtual TapeServer Quick Setup Guide | 15
D. Set the date, time, and time zone, as follows:
1. From the OS menu, select Administration→Date & Time. The Date/Time Properties
dialog is displayed:
2. Set the data and time on the Date & Time tab.
3. Click the Time Zone tab and set the time zone.
4. Click OK to save the date, time, and time zone settings and close the Date/Time
Properties dialog.
5. Reboot the system.
Note
If you need to configure path failover as described in the next section, you can
reboot after completing those steps.
E. To exit the interface, select Log Out from the OS menu. Click End Current Session on the
dialog that is displayed.