Virtual TapeServer 6.04.02 for NonStop Servers Quick Setup Guide

16 | Virtual TapeServer Quick Setup Guide
7 Configure and label ports
After cabling the host server and external devices to the VTS server, you must configure the
ports using the VTS web interface. This will enable VTS to communicate properly with each type
of device (target or initiator).
A. Launch a web browser and enter the IP address or hostname of the VTS server in the
address field. The VTS web interface is displayed:
B. Click Factory Setup on the navigation pane.
C. When prompted to log in, enter access as the username and verboten as the password.
D. Click Factory Options on the Factory Setup page.
E. Again, enter the login credentials.
F. Click Manage system limits. The Manage system limits page is displayed: