Virtual TapeServer 6.04.02 for NonStop Servers Quick Setup Guide

4 | Virtual TapeServer Quick Setup Guide
• Restraining any dangling items that can get caught in equipment.
• Working in an ESD-protected environment:
Gather network information
After you mount and cable the hardware, you must configure the following network settings if
you do not plan to use DHCP (DHCP is not supported with GFS):
• Fully qualified domain name
• IP address
• Subnet mask
• Default router (gateway)
• DNS or DHCP addresses with VTS name entered
A second set of IP settings may be required if configuring Instant DR or AutoCopy. It is
recommended that you segregate Instant DR and AutoCopy traffic from network and EMS traffic
to ensure adequate response times.