Virtual TapeServer 6.04.02 for NonStop Servers Quick Setup Guide

Virtual TapeServer Quick Setup Guide | 5
2Unpack and identify the hardware
Before mounting and cabling VTS, you must unpack the hardware and verify the box contents.
Unpack all hardware
A. Unpack all hardware and retain packing materials.
B. Inspect the hardware and the contents of the box(es). If damage is apparent, contact the
carrier and your vendor.
C. Place hardware on a flat, stable work surface. Always lift the enclosures by the sides.
Because the hardware is heavy, it is recommended that you use an assistant when lifting it.
Confirm that you received the following components, in addition to this guide and the hardware:
• VT5900-H and VT5900-J
• Power cords
• HP ProLiant Essentials Foundation Pack CDs
• HP ProLiant DL385 G5 Documentation CD and posters
• HP Virtual TapeServer Base Release 6.04 DVD
• Labels for bus numbers
•Rail kit
• VT5900-K
• Power cords
• HP ProLiant DL185 G5 Server Support and Documentation CD
• HP ProLiant DL185 Generation 5 Server Installation Sheet
• HP Virtual TapeServer Base Release 6.04 DVD
• External DVD/CD-ROM drive and USB cable
• Labels for bus numbers
•Rail kit
• SCSI converter (shipped with the VT5900-H)
• Power cord
•Rail kit
•SCSI cables
• Virtual TapeServer SCSI Interface Connection Module Sliding Rail Kit Installation guide
• VT5917 (may have been shipped with the VT5900-H or VT5900-J)
• Power cords
• Serial cable
•Rail kit
• VT5918 (may have been shipped with the VT5900-H or VT5900-J)
• HP StorageWorks Modular Smart Array 30 Installation Kit CD
• Power cords
• SAS cables
•Rail kit