Virtual TapeServer 6.04.02 for NonStop Servers Supplemental Installation Guide

16 | Enabling Instant DR and AutoCopy
e. Select System Network Device Control from pop-up list. The Network Device
Control window is displayed.
f. Select eth1 and click Configure. The Network Configuration window is displayed:
g. Double-click eth1.
h. Select Activate device when computer starts.
i. Select Statically set IP Addresses.
j. Provide the IP address, subnet mask, and default gateway. In this example, the
boston VTS server is configured with IP address 10.10.2.145, subnet mask
255.255.255.0, and default gateway 10.10.2.1.
Note eth1 must have a different IP subnet mask than eth0.
k. Click OK.