Virtual TapeServer 6.04.02 for NonStop Servers Supplemental Installation Guide

20 | Enabling Instant DR and AutoCopy
f. Add the name of all other VTS servers in this file. For example, on the Los Angeles
VTS server, enter boston.
g. Save and exit the file.
5. Set up and authorize secure shell (SSH) if you are configuring VTS for AutoCopy or if you
wish to secure communication for Instant DR.
a. At the command prompt, change to the /home/bill directory.
b. Enter ssh-keygen -t rsa.
c. Press ENTER to save the file in the default location. This step creates the /home/bill/
.ssh/ directory.
d. Press ENTER to skip the pass phrase.
e. Press ENTER to verify skipping the pass phrase.
f. Enter cd .ssh/.
g. Enter the following command:
ssh-copy-id –i /home/bill/.ssh/id_rsa.pub bill@boston
h. When prompted, enter yes.
i. Enter the password for the bill user at the destination server.
j. Repeat these steps for each VTS server. (If you are on losangeles, you must copy to
boston. If you are on boston, you must copy to losangeles.)
6. Check the RSH connection. At the command prompt, enter rsh server uptime. For
example, on the Boston server, enter rsh boston uptime.
This command displays the amount of time that the system has been up.
Repeat this step on each remote server. You should get similar results.
7. Check the SSH connection, if you configured SSH. At the command prompt, enter ssh
server uptime. For example, on the Boston server, enter ssh boston uptime.
The first time you enter an ssh command, a message similar to the following is displayed:
The authenticity of host 'server_name (IP_addr)' can't be
established.
RSA key fingerprint is
5f:10:3c:47:78:8f:e3:28:9d:ab:6b:34:ed:d1:e4:08.
Are you sure you want to continue connecting (yes/no)?
Enter yes.
8. Repeat these steps on each VTS server.
Note RSH and SSH can be setup for one direction or multiple directions. If multiple
directions are configured, these steps should be executed from the other direction.