Virtual TapeServer 6.04.02 Operations and Administration Guide

ManualsBrandsHP ManualsServerHP NonStop G-Series

111

112

113

114

115

116

117

118

119

120

Migrating Data to Physical Tape | 109

The VTSPolicy command for Syncsort Backup Express

Here is the syntax of the VTSPolicy command for use with Backup Express. Note that all

parameters specified for the command are case-sensitive.

VTSPolicy BEX 'backup_type /VAULTxx/pool/cartridge [keyword=value ...]'

where

backup_type.



Specifies the type of backup. You can specify one of the following values:

backup_base or backup_difr.

/VAULTxx/pool/cartridge

Specifies the pool and cartridge on which to operate. If you want to migrate an entire

pool, specify /VAULTxx/pool only.

keyword=value

Specifies valid keywords and their values, as follows:

source or s

Specifies the fully-qualified hostname of the VTS system on which the

specified pool resides. In a VTS cluster, this keyword specifies the VTS server

that will execute the command. This keyword is required in a VTS cluster.

erase Enables VTS to erase the virtual tape after migration is completed

successfully. Set this keyword to YES or NO. This keyword is not required

and defaults to NO.

For example, to migrate the virtual tape named CART01 on the VTS1 server and erase the

selected files from VTS, issue the following command:

VTSPolicy BEX 'backup_base /VAULT01/POOLA/CART01 s=VTS1 erase=YES'

The VTSPolicy command for Symantec Veritas NetBackup

Here is the syntax of the VTSPolicy command for use with NetBackup. Note that all