Virtual TapeServer 6.04.02 Operations and Administration Guide

44 | Configuring EMS Communication
8. Set the username and password for each EMS host:
a. Click Supervisor Functions on the navigation pane.
b. Click Manage Passwords. The following page is displayed:
c. From the drop-down list, select the EMS host.
Note If the EMS hostnames are not in the list, EMS may not be enabled.
d. In the Username field, type a username for that host.
e. In the New Password field, type a password for the user.
f. Retype the password in the New Password (again) field.
g. Click Update.
h. Repeat steps c-g for each additional EMS host defined in the configuration file.
Note Follow this procedure to change a password after it is set.
9. Click RESTART on the Virtual Media - Mounts and Locks page to restart the EMS
service. Or, click Start EMS Service on the Supervisory Functions page. You must start
or restart the service to enable VTS to reread the configuration file.