Virtual TapeServer 6.04.02 Operations and Administration Guide

45
Configuring Web Interface Preferences
This chapter describes how to configure web interface preferences by setting parameters in
the configuration file and how to set the refresh rate of the System Status page.
Enabling features on the web interface
You can set a number of parameters in the VTS configuration file to specify the following:
• Whether to display the buttons and features on the Virtual Media - Operation page.
• Whether and how often to display status messages at the top of the page.
• Whether and when to display a notification regarding low vault space.
• Whether to display the free space by vault on the System Status page.
• Whether to display buttons on the System Status page.
You must modify the VTS configuration file to configure these features.
Requires the Edit VTS Configuration File access right
To configure web interface preferences
Note
A default configuration file is defined for each VTS server. To override the default
settings, you must define settings as described below.
1. Click Supervisor Functions on the navigation pane.
2. Under Utilities, click Edit VTS Configuration File.
3. Add the following parameters at the bottom of the file that is displayed:
Parameter Description Values
opwin_Mount Displays the Mount button on the Virtual
Media - Operation page.
Default value: YES
YES or NO
opwin_Unmount Displays the Unmount button on the
Virtual Media - Operation page.
Default value: YES
YES or NO
opwin_Erase Displays the Erase button on the Virtual
Media - Operation page.
Default value: YES
YES or NO