Virtual TapeServer 6.04.02.01 for NonStop Servers Release Notes

Known Issues | 18
 Cartridge having less than minimum size is listed as erasable in Scan/Cleanup
after migration. If a cartridge is below the size specified by the cleanup_minimum_size_
MB parameter, the cartridge is scheduled to be erased by Scan/Cleanup after migration.
This is incorrect behavior; it should not be scheduled for erasure. (TL-444)
Migration
 Cartridge not ejected after migration by Legato. After migration is completed, the
cartridge should be ejected and put back in the tape slot. If Legato is used to migrate the
tape, the tape is not ejected as expected. (TL-2390)
 Misconfigured migration settings cause “Error: Can't find any files with data to
backup” error. If you do not specify a BMA in vts.conf, or if you misconfigure a
migration setting, the “Error: Can't find any files with data to backup message is
displayed, which does not indicate the problem. (TL-2645)
 Error, miscellaneous messages logged after successful NetBackup migration.
Message similar to the following are logged in the debug log after a successful migration
with NetBackup 6.5:
Fri Nov 7 14:45:27 2008: [slave_signal_thread 15713] SIGCHLD received
while no active child, ignoring it.
Fri Nov 7 14:45:32 2008: [cli_tape 0x05000107] ERROR UNKNOWN tape
command 0x44 for Id 0
Fri Nov 07 14:46:15 2008: [lsof.pl] Error: lsof.pl /usr/sbin/lsof |
grep "/VAULT00/MAXPOOL/MAX001" 2>&1 failed!, rc=1, error=No system
error detected. Please check application logs for application errors.
(errno=-1).
These messages are benign and can be ignored. (TL-2347)
 The hsm_summary_limit configuration parameter is not used. This parameter
should not be used and should be removed from the VTS configuration file. (TL-2272)
 Unable to unmigrate a pool. You cannot unmigrate the cartridges in a pool by selecting
the pool; you must select individual cartridges. (TL-386)
EMS
 Manual SSH connection must be made the first time EMS attempts to connect to
a remote host. When connecting with an SSH connection to a remote host for the first
time, the following message is displayed:
The authenticity of host 'dev4 (192.168.30.182)' can't be
established.
DSA key fingerprint is
88:96:0b:aa:dc:fa:c5:c6:90:8d:2a:08:12:c2:b4:23.
Are you sure you want to continue connecting (yes/no)?