Virtual TapeServer 6.04.02.01 for NonStop Servers Release Notes

Known Issues | 21
 cma.log fills without bounds causing the / partition to fill to 100%. 50 messages
similar to the following are written to /var/spool/compaq/cma.log every couple of seconds.
(TL-3465)
netsnmp_assert 1 == _access_interface_init failed if-mib/data_access/
interface.c:659 netsnmp_access_interface_entry_overrides_get()
netsnmp_assert 1 == _access_interface_init failed if-mib/data_access/
interface.c:276 netsnmp_access_interface_entry_create()
netsnmp_assert 1 == _access_interface_init failed if-mib/data_access/
interface.c:196 netsnmp_access_interface_index_find()
netsnmp_assert 1 == _access_interface_init failed if-mib/data_access/
interface.c:675 netsnmp_access_interface_entry_overrides()
netsnmp_assert 1 == _access_interface_init failed if-mib/data_access/
interface.c:659 netsnmp_access_interface_entry_overrides_get()
 Must reboot after disabling auditd logging. After you disable auditd logging, the
auditd service stops but due to a kernel defect, the output is directed to the console and /
var/log/messages. (TL-2465, EAR 4787)
WORKAROUND: Reboot after disabling auditd logging (chkconfig auditd off).
 Message logged to console and /var/log/messages until iLO is configured. Until
HP-iLO is configured, the following message may continue to print the following message:
INIT: Id "s1" respawning too fast: disabled for 5 minutes
The message is also logged to /var/log/messages with no other information. (TL-2279)
Installation, upgrades, updates, and restore
 Must log in three times before upgrading. When you try to log in to the web interface
to upgrade from 6.04.01 to 6.04.02, you must enter the username and password three
times before it logs you in. (TL-3340)
 /usr/local/tape/log/event.log is owned by root not bill after upgrade. After
upgrading from 6.04.01 to 6.04.02, the /usr/local/tape/log/event.log file is owned by root
not bill and the web interface indicates that you cannot open the file. (TL-3339)
WORKAROUND: Change the ownership of the event.log file to bill by entering this
command: chown bill.bill /usr/local/tape/log/event.log
 Downgrade fails if GRUB is not manually installed. If you downgrade from 6.04.02
using the Revert VTS Revision Update link on the VTS web interface and reboot
immediately after downgrading, VTS may hang with “GRUB” displayed on the screen.
(TL-3189)
WORKAROUND: To avoid this problem, perform the downgrade as documented in the
Virtual TapeServer Operations and Administration Guide. If this problem does occur,
perform the following steps to correctly downgrade the server:
a. Boot VTS using the 6.04.01 or 6.04.02 Install and Rescue DVD.
b. Select rescue at the boot prompt.
c. When prompted to start the network interfaces, select No.
d. Select Continue when prompted to mount the Linux installation.
e. Press ENTER (or select OK) when prompted after the drives are mounted.