Virtual TapeServer 6.04.03 for NonStop Servers Quick Setup Guide

Virtual TapeServer Quick Setup Guide | 15
3. Double-click the device to modify on the Devices tab. The Ethernet Device dialog is
displayed:
4. Configure the device with static IP settings, or select the option to use DHCP. Then, click
OK to return to the Network Configuration dialog.
5. Click the DNS tab and type the IP address of your DNS server(s) and the domain (DNS
search path).
Note
Do not set the hostname on the DNS tab. You will set this value on the Hosts tab
instead.
6. Click the Hosts table and click New to set the hostname of the VTS server. The Add/Edit
Hosts entry dialog is displayed.
7. Type the fully qualified domain name you want to assign to the VTS server in the
Hostname field, and then specify the IP address and alias (short hostname). Then, click
OK to return to the Network Configuration dialog.
8. Save the settings.
9. Click on the Devices tab, select eth0 (or eth1), and click Activate. When prompted,
click Yes to save the changes. Then, click OK on the next popup dialog.
10. Close the Network Device Control dialog.