Virtual TapeServer 6.04.03 for NonStop Servers Quick Setup Guide

16 | Virtual TapeServer Quick Setup Guide
E. Set the date, time, and time zone, as follows:
1. From the OS menu, select Administration→Date & Time. The Date/Time Properties
dialog is displayed:
2. Set the date and time on the Date & Time tab.
3. Click the Network Time Protocol tab and enable NTP. Then, add NTP servers.
4. Click the Time Zone tab and set the time zone.
5. Click OK to save the date, time, and time zone settings and close the Date/Time
Properties dialog.
6. Reboot the system.
Note
If you need to configure path failover as described in the next section, you can
reboot after completing those steps.
7. To verify that the fully qualified domain name is set correctly for the VTS server, enter
the following from the command line.
hostname --fqdn
If this is not correct, return to the Network Device Control dialog and correct the
problem.
F. Replace the server certificate. VTS ships with a self-signed certificate that is used to
establish a secure communication channel between your browser and the VTS web
application server, through Secure Sockets Layer (SSL). After the hostname is set on the
server, you must regenerate the certificate with the new hostname. (Later, you can generate