Virtual TapeServer 6.04.03 for NonStop Servers Supplemental Installation Guide

26 | Enabling Enterprise Integration and Migration
[RelAdr=0] WBus16=1 Sync=1 Linked=0 [TranDis=0] CmdQue=0
Clocking=0x3 QAS=0 IUS=0
length=74 (0x4a) Peripheral device type: tape
Vendor identification: CERTANCE
Product identification: ULTRIUM 3
Product revision level: 1770
Product serial number: JD006D2
Repeat for each tape drive that was added.
Configuring migration
Be sure that the backup management application client is installed and configured on the
VTS server. Refer to the backup management application documentation for more
information. Then, modify the VTS configuration file to configure migration, which entails
configuring the hsm_ parameters as defined below, and set the username and password.
Note A default configuration file is defined for each VTS server. To override the default
settings, you must define settings as described below.
Requires the Edit VTS Configuration File access right
To configure migration
1. Click Supervisor Functions on the navigation pane of the VTS interface.
2. Click Edit Configuration File.
3. Add the following parameters at the bottom of the file that is displayed:
Parameter Description Values Req’d?
hsm_enable Enables migration.
Default value: YES
YES or NO Yes
hsm_product Identifies the backup management
application:
• TSM for Tivoli Storage Manager
• LEG for Networker
• BEX for Backup Express
• NBP for NetBackup
• CMV for CommVault Galaxy
For automated migration, you can
specify any of these values, which
depends on the backup management
application.
Default value: TSM
TSM, LEG,
BEX, NBP, or
CMV
Yes