Virtual TapeServer 6.04.03 for NonStop Servers Supplemental Installation Guide

31
SCSI-to-Fibre Channel Adapter Upgrade
This chapter provides instructions to replace one or more SCSI cards with the same number of
VTS-supported Fibre Channel cards on the following VTS models:
• VT5900-E, on the HP ProLiant DL385 G2
• VT5900-H, on the HP ProLiant DL385 G5
Refer to Upgrading a SCSI Adapter to a Fibre Channel Adapter on page 45 if you need to
upgrade legacy hardware.
Requires the View/Manage Configuration and Factory Setup Activities access rights
To replace SCSI cards with Fibre Channel cards and reconfigure VTS
1. Switch all buses to Physical (Tape) mode and block startup.
a. On the VTS web interface, click Factory Setup on the navigation pane.
b. When prompted, enter the login credentials.
c. Click Factory Options and enter the login credentials again.
d. Click Manage system limits. The Manage system limits page is displayed.
e. Write down the current configuration. Note the following:
• Grey boxes indicate buses on the SCSI card(s)
• Yellow boxes indicate ports on the Fibre Channel card(s); hold your cursor over
the checkbox to view the speed of the port
f. Select the Physical checkbox for all buses and then click Set Limits.