Virtual TapeServer 6.04.03.02 for NonStop Servers Release Notes

Installation and Configuration | 2
Installation and Configuration
This section describes how to access information about installing and configuring the release
6.04.03.02 of VTS. It also provides compatibility notes.
Upgrades
If you are upgrading from 6.03.x, you must upgrade to 6.04.01 before upgrading to 6.04.03.
Refer to the 6.04.01 Virtual TapeServer Release Notes and Operations and Administration
Guide for information about upgrading to 6.04.01.
Before installing the 6.04.03.02 interim release (IR), you must first upgrade to 6.04.03. To
upgrade from 6.04.03, refer to the upgrade appendix in the Virtual TapeServer Operations
and Administrative Guide.
Upgrading to 6.04.03.02
It is highly recommended that you back up your system(s) in your environment. See the
backup procedure in the Virtual TapeServer Operations and Administrative Guide for
instructions.
To install the IR on a 6.04.03 Virtual TapeServer server
1. If necessary, unzip the IR package. Then, on the system from which you access the Virtual
TapeServer server, copy the .VTSINSTALL and .VTSUNINSTALL files to a local
directory.
2. From the Virtual TapeServer web interface, click Supervisor Functions on the
navigation pane. The Supervisory Functions page is displayed.
3. Click Apply Software Change and browse to the .VTSINSTALL file.
4. Click UPLOAD.
5. Click Apply to apply the changes.
VTS automatically reboots.
Downgrading from 6.04.03.02
To uninstall the IR
1. From the Virtual TapeServer web interface, click Supervisor Functions on the
navigation pane.
2. Click Apply Software Change and browse to the .VTSUNINSTALL file.
3. Click UPLOAD.
4. Click Apply to apply the changes.
5. If the uninstall fails and an error similar to the following is displayed, which indicates
that IR files were modified since the IR was applied, you must perform additional steps:
ERROR: File does not match version applied by release:
/path_to_altered_file
...