Virtual TapeServer 6.04.04 for NonStop Servers Installation Guide

11
Configuring Ports and Licensing
To complete configuration, you must configure ports and licensing. This chapter describes
these procedures.
Configuring ports
After cabling the host server(s) and external devices to the VTS server, you must configure
the ports to enable VTS to communicate properly with each device (target or initiator). Or, if
you attach a physical tape drive or storage device to the server after initial configuration, you
must define the port as physical.
Requires the View/Manage Configuration access right
To configure ports
1. To access the web interface, launch a web browser and enter the following in the address
field:
https://ip_address
where ip_address is the management network interface address.
Or, if the Domain Name System (DNS) is configured on the network, enter the following:
https://hostname
2. If prompted, log in to the web interface as a user who has the View/Manage Configuration
access right. Refer to
Credentials on page 43 for a list of default user accounts.