Virtual TapeServer 6.04.04 for NonStop Servers Installation Guide

12 | Configuring Ports and Licensing
3. Click Manage Connections on the navigation pane. Ports are configured in the
MANAGE PORT CONFIGURATION section of the page. (An image of your server will be
displayed. The example below is an image of the DL380 G6.)
4. Configure each port as described in the help. To view the help, click the Help button at
the top of the page.
Configuring licensing
Before you can use Virtual TapeServer (VTS), you must enable licensing. You can enable
licensing for the following:
• Standalone virtual tape drives (VTDs) and compression, if included
• SecureVTS
• Instant DR, which also enables AutoCopy
To request license keys, contact the HP VTS Program Manager, Glenn Garrahan, at
[e-mail]. VTS software license keys are associated with the serial number of
the VTS server, so any server hardware replacement or upgrade will requires new license
keys. Obtain a set of license keys for each VTS server in your environment.
Note If the VTS server was upgraded, you may need a vpd.enc file (referred to as the Vital
Product Data, or VPD, file) before you can enable licensing. See the “Upgrading to
6.04” section of the Virtual TapeServer Administration and Operations Guide, which
an be found at http://docs.hp.com/; search for “Virtual Tape Server 6.04 Operations
and Administration Guide”.
The full procedure is documented in the online help, which is accessed by clicking the Help
button on the Manage System Licenses page of the VTS web interface.