Virtual TapeServer 6.04.04 for NonStop Servers Installation Guide

16 | Creating Virtual Tape Drives
The following procedure describes how to create a VTD using the Manage Connections page.
The full procedure is documented in the online help, which is accessed by clicking the Help
button on the Manage Connections page of the VTS web interface.
Note At least one port must be set to Virtual (target) mode on the Manage Connections
page before you can create a VTD. Ports should have been configured as described in
the help.
Requires the View/Manage Configuration access right
To add a VTD
1. If you have not enabled VTD licensing or if no VTD licenses remain (as indicated in the
INFORMATION section of the Manage Tape Connections page), you must enable
licensing or add a new license before you can create VTDs. See
Configuring Ports and
Licensing on page 11 for more information.
2. Log in using an account that has the access right listed above. Click the Log In button at
the top of the page and enter a username and password. See
Credentials on page 43 for a
list of default user accounts.
3. Click Manage Connections on the navigation pane. The Manage Connections page is
displayed: