Virtual TapeServer 6.04.04 for NonStop Servers Operations and Administration Guide

Troubleshooting | 115
Export log
This log provides information about all export operations. If a problem occurs, a return code is
listed in the log file, such as in this example:
000000016: Fri Jun 11 10:45:02 2010: NSPOOL:V16009 Rewind failed! /dev/nst2, rc=1
Here is an explanation of the return codes that may be displayed in this log:
53 Virtual tapes
61 Access Control defaults
62 Access Control users
63 Access Control groups
64 Access Control rights
65 Secure password management
71 Erase by list
72 Delete by list
81 Crumb
91 System status
Return
Code
Possible Cause(s) Corrective Action(s)
-1 • File is empty on export
• Rewind failed
• Parameters incorrect or missing
(internal error)
• Retry with a non-empty file
• Load tape in drive
• Make sure tape drive is on and
properly configured
• Check cabling
1 Could not allocate buffer (malloc) N/A
2 Could not lock memory (mlock) N/A
3 • Could not open data source file
• Invalid data source file specified
or file not found
Specify a valid source file
4 Could not open physical tape drive;
usually due to a configuration error
• Make sure tape drive is on and
properly configured
• Check cabling
5 Could not load and rewind tape
before copy
• Load tape in drive
• Make sure tape drive is on and
properly configured
• Check cabling
ID Subsystem