Virtual TapeServer 6.04.04 for NonStop Servers Quick Start Guide

Virtual TapeServer Quick Start Guide | 17
Here is an example of the PuTTY configuration:
3. For an Ethernet connection, specify the IP address of eth1 (1.1.1.1) on the VTS server,
specify a port, and select a connection type. Here is an example of the PuTTY
configuration:
4. Open the connection.
B. At the command prompt, log in as root. When prompted, enter the current password, which is
v-serial#_in_reverse (such as v-75001A if the serial number is A10057), and then set a new
password. An acceptable password must comprise eight characters, including one numeric
character, one uppercase character, one lowercase character, and one other (non-
alphanumeric) character.