Virtual TapeServer 6.04.04 for NonStop Servers Release Notes

Upgrade and Downgrade | 6
9. If you are upgrading from 6.04.01 or 6.04.02 to 6.04.04, complete these steps:
a. Type the full path to the UPG file in the field:
b. Click SUBMIT to begin the upgrade.
c. Verify that the following messages are listed on the page:
You MUST re-run this upgrade for the process to complete!
Revision Update Successful!
System must now be rebooted.
d. Do not reboot. Instead, click Supervisor Functions on the navigation pane.
e. Click Apply Revision Update.
10. Select From File on the following page.
11. In the Location of Revision Update File field, type the full path to the UPG file.
12. Click UPGRADE.
13. Click OK to continue.
14. Confirm that the following message is displayed:
Completing Upgrade...
Revision Update Successful!
System must now be rebooted.
15. Click REBOOT to complete the update.
Contact Support if the upgrade fails, such as if the server is installed on unsupported
hardware.
Updating the VTS server
Before installing an interim release (IR, or “patch”), you must first upgrade to 6.04.04 as
described above. The following provides the general steps for installing an IR.
Note It is highly recommended that you back up the system(s) in your environment. See the
backup procedure in the Virtual TapeServer Operations and Administrative Guide for
instructions.