Manualshelf

Virtual TapeServer 6.04.04 for NonStop Servers Supplemental Installation Guide

ManualsBrandsHP ManualsServerHP NonStop G-Series
11121314151617181920
Installing GFS | 7
Note the URL given in the output; you will access it in the next step.
d. Configure the cluster using the luci web interface:
• Access the web interface by loading the URL given in the previous step in a web
browser.
• When prompted, accept the certificate permanently.
•Click OK if a certificate domain mismatch warning is displayed.
• Log in by entering the luci admin username and password.
•Click Add a System.
• Enter the fully qualified domain name of the GFS system.
• Enter the root password for that system.
•Click Add another entry.
• Enter each cluster member's name and root password, and click Submit.
•Click the Cluster tab at top of the page.
•Click Create a New Cluster.
• Enter the same cluster name specified in step 11a.
• Enter each system's fully qualified domain name and root password.
• Select Use locally installed packages.
• Make sure Enable Shared Storage Support is selected.
•Click Submit.
Although the interface states that the systems are rebooted, they are not.
13. Configure fencing:
a. In the browser, under the cluster name in the left column, click Nodes.
b. For each node, click Manage Fencing for this Node.
c. Under Main Fencing Method, click Add a fence device to this level.
d. Select brocade fabric switch.
e. Enter the hostname of the Fibre Channel switch. Consult your SAN administrator for
this information.
f. Enter the IP address of the Fibre Channel switch. Consult your SAN administrator
for this information.
g. Enter the username for accessing the Fibre Channel switch. Consult your SAN
administrator for this information.
h. Enter the corresponding password. Consult your SAN administrator for this
information.
i. Enter the port of the Fibre Channel switch. Consult your SAN administrator for this
information.
j. Click Update.
Repeat these steps for each node in the cluster.
14. Add GFS storage to the cluster:
a. In left-hand column of the web interface, under the cluster name, click Resources.
b. Click Add a resource.