Virtual TapeServer 6.04.05 for NonStop Servers Release Notes

Known Issues | 16
 During boot up, warning messages displayed about already initialized
constants. When booting up, there are warning messages printed to the console, which
can be ignored. (TL-5888)
Starting vts xmlrpc server
Server started successfully, pid file is in /var/www/media/lib
Starting cleanup_suspended_jobs.rb: [ OK ]
Starting cleanup_termination_fifos.rb: [ OK ]
Starting clear_per_destination_transfer_counters.rb: ** Loaded vendor
plugin: Certificates
/var/www/media/lib/rath_initializer.rb:21: warning: already
initialized constant APPLOG
/usr/lib64/ruby/gems/1.8/gems/rath-0.1/lib/rath/models/job_run.rb:14:
warning: already initialized constant SUCCESS
/usr/lib64/ruby/gems/1.8/gems/rath-0.1/lib/rath/models/job_run.rb:15:
warning: already initialized constant FAILURE
...
 Kernel panic displayed on console. This issue can be caused when activity occurs on
the SCSI bus (such as an unmigrate) when Tapeserver is restarted. (TL-6005)
 Communication with remote host fails if ICMP is blocked. Remote hosts used for
SecureVTS backups, Instant DR, and AutoCopy attempt to ping the backup server name.
If ICMP is blocked, adding the backup host fails even if SCP is configured and functioning
properly. (TL-4371, EAR 6359)
 VTDs not detected by AIX if more than 31 are created on single port. If more than
31 VTDs are created on a single port, AIX will only detect the first one. (TL-5179)
 Writing to VTD fails if you attempt to create a VTD on same bus. If data is being
written to a VTD and you attempt to create a VTD on the same bus, writing fails with this
error: Cannot write: Input/output error (TL-4464)
 Mode page response to compression is enabled by default. This setting is enabled
by default and static for each emulation. However, compression may be turned off in the
configuration file, but the SCSI response to the mode sense request indicates that
compression is on. (TL-4141)
 Import fails if virtual tape meets pool cartridge quota when it is exported. If a
quota size is set for a pool and you export a virtual tape in the pool that meets that quota,
imports will fail if the cartridge is the maximum size allowed. If the cartridge is not full,
imports work fine. (TL-4046)
 Incorrect response from Ultrium 1 drive causes import and/or export to fail. A
physically connected HP Ultrium 1 drive fails to allow a rewind when the medium
removal is prevented by SCSI command. (TL-4035)
 Exporting a pool using a 5190 tape drive fails. The following error message is
generated. (TL-4073)
Fri 2010-01-08 13:26:35: V01POOL:* /usr/bin/star -c f=/dev/nst0 C=/
VAULT00/V01POOL H=pax bs=256k V10001 V10002 V10003 V10004
000000007: Fri 2010-01-08 13:26:35: V01POOL:* Exporting pool...
000000007: Fri 2010-01-08 13:26:35: V01POOL:* Failure writing data to
/dev/st0, rc=22