Virtual TapeServer 8.0 Configuration Guide

Configuring User Accounts | 103
Note In the following procedures, if the Users and Groups and Rights sections of the
Manage Access Control page are not available, you must enable a closed system.
These sections are not displayed if the system is configured as open access.
Enabling a closed system using default users and groups
You can enable a closed system to require authentication. The user can access only the
resources assigned to a particular group. You can enable or disable individual rights to
resources.
Requires the System Access Controls access right
To enable a closed system
1. Click Security→Access Control on the navigation pane.
2. If prompted, log in. After logging in, the Manage Access Control page is displayed.
3. Under Defaults and Undo, click the Restore CLOSED Defaults button, which restores
all default users, groups, and rights.
4. Click OK on the pop-up dialog box to confirm that you want to restore closed defaults.
Below are closed system defaults:
• Users — The following users are defined.
• Groups — The following rights are assigned to the groups:
Note The rights are organized in categories. If you grant access to a category, all rights
in the subcategories are granted by default, though you can remove individual
rights in the subcategories.
Username Group
admin Administration
operator Operations
tapelabs Supervisor