Virtual TapeServer 8.0 Quick Start Guide

Virtual TapeServer Quick Start Guide | 17
Here is an example of the PuTTY configuration:
3. For an Ethernet connection, specify the IP address of eth1 (1.1.1.1) on the VTS server,
specify a port, and select a connection type. Here is an example of the configuration:
4. Open the connection.
B. Complete these steps to log in:
1. At the command prompt, log in as bill.
2. Enter the current password for bill, which is v-serial#_in_reverse (such as v-75001A if
the serial number is A10057).
Note
The serial number is provided on a label on the back of the server.
3. When prompted, set a new password for bill. An acceptable password must comprise
eight characters, including one numeric character, one uppercase character, one
lowercase character, and one other (non-alphanumeric) character.