Virtual TapeServer 8.0 Supplemental Installation Guide

22 | Enabling and Configuring AutoCopy and Instant DR
You may use Autocopy and Instant DR separately or at the same time. However, if Autocopy
and Instant DR are used simultaneously, it should be noted that they may not be run on the
same virtual tapes. For example, you may run Autocopy on vtapeA in PoolXYZ while also
running an Instant DR job on vtapeB in PoolXYZ. However, you cannot run Autocopy on
vtapeA in PoolXYZ and then immediately run an Instant DR job for PoolXYZ in its entirety.
This is because vtapeA will be in use and locked by Autocopy. In this case, the Instant DR job
would fail.
Configuring network settings and TCP/IP security
You must configure network settings and TCP/IP security for all VTS locations. To configure
the local system, you must attach a monitor, keyboard, and mouse to the VTS server. To
configure remote systems, you must use a remote-access application to access those systems,
or perform the steps at each site. The IP address, which will differ for each VTS server, must
be configured at the local and remote sites. Consult your network administrator to determine
the gateway and subnet mask to use for each system.
In addition, you should be familiar with networking concepts to complete the steps in this
section. Obtain the following information before beginning this procedure:
• Root access to the VTS system; see the Configuration Guide for a list of the default
accounts provided on the server
• IP address, subnet mask, and gateway of each VTS server
At what level are changes
made (implementation
granularity)?
Vault, pool, or virtual tape Pool only
How much data is
transmitted?
Data difference only, which
may reduce data
transmission
Bit-for-bit (1:1) copy
operation
When is bandwidth
consumed?
Per schedule, usually off-
hours
Throughout the day, may
coincide with user activity
How many backup sites are
supported?
Multiple sites, from one site
to many based on setup
Single site, from one site to
another
Is tuning supported? Initiates multiple jobs to
overcome delays
Single job only
Instant DR AutoCopy