Virtual TapeServer 8.2 Configuration Guide

115
Configuring Web Interface Preferences
This chapter describes how to configure web interface preferences by setting parameters in
the configuration file and how to set the refresh rate of the System Status page.
You can set a number of parameters in the VTS configuration file to specify the following:
• Whether and how often to display status messages at the top of the page.
• Whether and when to display a notification regarding low vault space.
• Whether to display the free space by vault on the System Status page.
• Whether to display buttons on the System Status page.
• Whether to display the buttons and features on the Configure Tapes and Pools page.
You must modify the VTS configuration file to configure these features.
Requires the Edit Configuration File access right
To configure web interface preferences
Note
A default configuration file is defined for each VTS server. To override the default
settings, you must define settings as described below.
1. Click Configuration→System on the navigation pane.
2. Click Edit Configuration File.
3. Add the following parameters at the bottom of the file that is displayed:
Parameter Description Values
opwin_Mount Displays the Mount button on the
Configure Tapes and Pools page.
Default value: YES
YES or NO
opwin_Unmount Displays the Unmount button on the
Configure Tapes and Pools page.
Default value: YES
YES or NO
opwin_Erase Displays the Erase button on the
Configure Tapes and Pools page.
Default value: YES
YES or NO
opwin_Delete Displays the Delete button on the
Configure Tapes and Pools page.
Default value: YES
YES or NO