Virtual TapeServer 8.2 Quick Start Guide

Virtual TapeServer Quick Start Guide | 3
For the eth0 port, gather this information if you do not want to use DHCP:
• IP address: ______________________________________________________________
• Subnet mask: ____________________________________________________________
•Default gateway: _________________________________________________________
• IP addresses of DNS servers: ________________________________________________
• DNS search domains: ______________________________________________________
If a second subnet is available, you can use eth1 for replication (if the Data Replication Suite is
licensed). It is recommended that you use eth1 in addition to eth0 to segregate replication traffic
from network traffic to ensure adequate response times.
Note
If a second subnet is not available, you cannot use eth1.
For the eth1 port, gather this information if you do not want to use DHCP:
• IP address: ______________________________________________________________
• Subnet mask: ____________________________________________________________
•Default gateway: _________________________________________________________
Finally, in order to log in to configure network settings, you must obtain the serial number of the
VTS appliance. Note the serial number that is provided on a label on the back of the appliance.
Serial number: ______________________________________________________________
Refer to the Configuration Guide for instructions to fully configure network settings.
Obtain tools and supplies for installation
You may need the following items to complete the installation instructions:
• #2 Phillips screwdriver
• Tape measure
• One of the following to access the command line interface and set up VTS:
• Terminal or a computer running a terminal emulation program
• Keyboard and monitor, plus a VGA cable to connect the monitor to VTS