Virtual TapeServer 8.3 Configuration Guide

Configuring User Accounts | 135
Managing web interface accounts
Here is a list of the default user accounts provided for accessing the VTS web interface:
Username Default
Password
Group Privileges
operator tapelabs Operations Can view system status, including vaults.
tapelabs tapelabs Supervisor Can perform all VTS functions but cannot
administer access control, edit the VTS
configuration file, restore the Linux
configuration, or view and manage
configurations.
admin virtual Administration Can access all VTS functions
If you have system administrator privileges, you can configure access control to grant or limit access
to specific VTS functions. Each login ID belongs to a group and each group has a unique set of
privileges.
Note VTS provides a user that has administrator privileges. You can log in as admin if no other
administrative user is created on the system. The default password for this user is virtual.
By default, VTS is a closed system, which means that users are required to authenticate before they
can access the web interface. Access control enables you to establish rights for specific users or
classes of users. You can fine tune control of VTS system resources on a group-by-group basis. A
closed system requires authentication to access resources assigned to a particular group. You can
enable or disable individual rights to resources.
Note In the following procedures, if the Users and Groups and Rights sections of the Manage Access
Control page are not available, you must enable a closed system. These sections are not
displayed if the system is configured as open access.