Virtual TapeServer 8.3 Configuration Guide

78 | Virtual TapeServer Configuration Guide
c. Add the following parameters at the bottom of the file that is displayed:
Parameter Description Values
cleanup_threshold_
percent
Indicates the threshold after which a
cleanup is initiated, if Scan/Cleanup is
enabled. When the VTS file system reaches
this threshold (a percentage), virtual tapes
can be scheduled for erasure if this
parameter is set. This parameter also
instructs VTS to send a notification to the
NonStop server.
Default value: 100
Integer
opwin_filesystem_alert Sets the percentage for the /VAULTxx file
system usage; if this usage is exceeded, a
message is sent to the NonStop server (and
an alert is displayed on the VirtualMedia -
Operation page of the web interface).
Default value: 90
Integer
lowspace_notify Enables notification on low vault space; a
message is sent to the NonStop host server
(the ems_hsm_backup_notification
parameter must also be set to YES).
Default value: YES
YES or
NO
lowspace_notify_
percentage
Specifies the percentage of free space that
must be available; if the amount of free
space falls below this percentage, the low
vault space notification is sent to the
NonStop server.
Default value: 5
Integer
d. Click the SAVE button.
If problems arise, check the ems.log file to confirm that the login to the host server and the prompt
response are correct.