Virtual TapeServer 8.3 Quick Start Guide

14 | Virtual TapeServer Quick Start Guide
c. For an Ethernet connection, specify the IP address of eth1 (1.1.1.1) on the VTS server,
specify a port, and select a connection type. Here is an example of the PuTTY
configuration:
d. Open the connection.
2. Complete these steps to log in:
a. At the command prompt, log in as bill.
b. Enter the current password for bill, which is v-serial#_in_reverse (such as v-75001A if
the serial number is A10057).
Note The serial number is provided on a label on the back of the server.
c. When prompted, set a new password for bill. An acceptable password must comprise at
least eight characters, including one numeric character, one uppercase character, one
lowercase character, and one other (non-alphanumeric) character.
d. Become root:
su -