Virtual TapeServer 8.3 Supplemental Installation Guide

SCSI-to-Fibre Channel Adapter Upgrade | 43
2. Remove the SCSI card in slot 4 and install the second Fibre Channel card in slot 4, if
necessary.
Here is a snapshot of the SCSI card after it is removed:
g. After you install the Fibre Channel upgrade cards in the appropriate slots, make sure
the blue clips are firmly seated and locked in place on each slot. Then, re-install the PCI
Riser cage in the DL385 G2 chassis. Once aligned, firmly press the module into place.
Re-tighten the two blue pull tabs on the PCI Riser cage.
h. Place the top cover back in place and secure it. Slide the HP DL385 G2 ProLiant server
back into the rack and secure the two quick-disconnect screws on the front panel.
i. From the rear of the HP ProLiant DL385 G2 server, reconnect any remaining SCSI
cables to the same ports where they were originally connected, if necessary. Because
you removed one or more SCSI cards, you will have extra, unused SCSI cables.
Reconnect the power cords.
5. Restart VTS.
a. Power on the ProLiant server by pushing the power button on the front panel. The
restart process begins and is complete when the screen displays a login prompt.