Virtual TapeServer 8.3 Supplemental Installation Guide

Hardware Information for Legacy Installations | 65
Here is a snapshot of the SCSI card after it is removed:
7. After you install all of the Fibre Channel upgrade cards in the appropriate slots, make sure the
blue clips are firmly seated and locked in place on each slot. Then, re-install the shipping
bracket and make sure the pull tab is secure.
8. Place the top cover back in place and secure it. Slide the HP DL585 ProLiant server back into
the rack and secure the two quick-disconnect screws on the front panel.
9. From the rear of the HP ProLiant DL585 server, reconnect any remaining SCSI cables to the
same ports where they were originally connected, if necessary. Because you removed one or
more SCSI cards, you will have several extra, unused SCSI cables. Reconnect the power cords.
Now, continue with step 5 on 43 and step 6 on page 44.
On the HP ProLiant DL380 G4 (VT5900-B and VT5900-C)
After completing step 3 on 41, remove the SCSI card(s) and install the Fibre Channel card(s), as
follows:
1. From the rear of the HP ProLiant DL380 server, mark each SCSI cable with the port position to
which it is attached. This will make it easier to reattach them to the correct SCSI ports later.
2. Disconnect the ProLiant power cords as a precaution. Disconnect all SCSI cables from the SCSI
adapters for easier access to the adapter cards.