Virtual TapeServer 8.3 Supplemental Installation Guide

Hardware Information for Legacy Installations | 67
Here is a snapshot of the SCSI card after it is removed:
7. After you install all of the Fibre Channel upgrade cards in the appropriate slots, make sure the
blue clips are firmly seated and locked in place on each slot. Then, re-install the PCI Riser cage
in the DL380 chassis. Once aligned, firmly press the module into place. Re-tighten the two blue
pull tabs on the PCI Riser cage.
8. Place the top cover back in place and secure it. Slide the HP DL380 ProLiant server back into
the rack and secure the two quick-disconnect screws on the front panel.
9. From the rear of the HP ProLiant DL380 server, reconnect any remaining SCSI cables to the
same ports where they were originally connected, if necessary. Because you removed one or
more SCSI cards, you will have extra, unused SCSI cables. Reconnect the power cords.
Now, continue with step 5 on 43 and step 6 on page 44.
For step 7c on 44, consider the following slot-to-port relationships on the HP ProLiant DL380 G4
(VT5900-B and VT5900-C):
PCI-X Slot Bus Number Virtual Tape Name
3 A 0 $VTAPE00
3 B 1 $VTAPE01