Virtual TapeServer 8.4 Configuration Guide

194 | Virtual TapeServer Configuration Guide
Severity ID Subsystem
ID
Event
ID
Subsystem Message text
notify_percentage <vault>
8 91 004 System Status Warning: low space cleanup_
threshold_percentage <vault>
Export log
This log provides information about all export operations. If a problem occurs, a return code is listed
in the log file, such as in this example:
000000016: Fri Jun 11 10:45:02 2010: NSPOOL:V16009 Rewind failed!
/dev/nst2, rc=1
Here is an explanation of the return codes that may be displayed in this log:
Return
Code
Possible Cause(s) Corrective Action(s)
-1
l File is empty on export
l Rewind failed
l Parameters incorrect or
missing (internal error)
l Retry with a non-empty file
l Load tape in drive
l Make sure tape drive is on
and properly configured
l Check cabling
1 Could not allocate buffer (malloc) N/A
2 Could not lock memory (mlock) N/A
3
l Could not open data source
file
l Invalid data source file
specified or file not found
Specify a valid source file
4 Could not open physical tape drive;
usually due to a configuration error
l Make sure tape drive is on
and properly configured
l Check cabling
5 Could not load and rewind tape
before copy
l Load tape in drive
l Make sure tape drive is on
and properly configured