Virtual TapeServer 8.4 Configuration Guide

26 | Virtual TapeServer Configuration Guide
4. Configure each port that is used to attach VTS to an external storage device (tape drive,
library, or disk array). From the drop-down list for the port attached to the device, select
physical.
5. Click Submit.
6. When prompted, click OK to confirm that you want to reboot the server.
7. On the Reboot The System - Confirmation page, click REBOOT.
If problems arise:
l Make sure there are no bus conflicts with a physical drive or library on a virtual port or with
a host server on a virtual port.
l Note that you can set the mode of supported HBAs only.