Virtual TapeServer 8.4 Configuration Guide
Enabling and Configuring Data Replication | 59
7. In the Target Host field, type the fully qualified hostname or IPaddress of the target server.
Note It is recommended that you provide a hostname, if DNS is configured on your network. If
you provide an IP address instead of a hostname and then the IP address of the source
or target server changes, you must delete the target server and then complete all
configuration procedures again.
8. In the Http Port field, type the port number used for accessing the web interface on the target
system. Typically, this port is set to 80 but it may be set to another number if, for example,
the server is behind a firewall. Contact your firewall or system administrator for this port
number.
9. In the Ssh Port field, type the port number used to access SSH on the target server. Again, if
the server uses a non-standard port, contact your firewall or system administrator.
10. In the Bandwidth Limit field, type the number of kilobytes per second that the source server
can use to send data. If you specify 0, no limit is set.
11. Click Save.
To authorize and enable a source server
Complete these steps using the target server's web interface:
1. Click Configuration > System on the navigation pane.
2. Click Edit System Settings.
3. Click Replication Settings to expand this area of the page. The following is displayed:
4.
Click next to the source server you want to authorize and enable.
5. Select the Authorized checkbox to verify that the source credentials are valid and expected.