Virtual TapeServer 8.4 Configuration Guide

60 | Virtual TapeServer Configuration Guide

6. Select the Enabled checkbox to enable the source server, thereby allowing it to use the local

(target) system as a replication target. (You cannot select this checkbox if the Authorized

checkbox is not selected.)

7. In the Friendly Name field, type a name for the source server.

8. Using the Map To lists, map mount points (data volumes) on the local (target) server to the

source server. This determines where replicated tapes are stored on the local server when

sent from this source server. Use the and buttons to move mount points to and from the

lists.

9. Click Save.

To complete the connection and enable the target server

After the target authorizes and enables this source, complete these steps using the source server's

web interface:

1. Click Configuration > System on the navigation pane.

2. Click Edit System Settings.

3. Click Replication Settings to expand this area of the page. The following is displayed:

Test the connection to the target server. Click in the Actions column next to the target

server.

5. In the Test Target Connection section of the page, select Yes to continue the connection and

then click Submit.

Enable the target server by clicking next to the target server and then selecting the

Enable checkbox. Then, click Save. The server will then be available for selection during

replicate job creation.