Virtual TapeServer 8.4 Quick Start Guide

Virtual TapeServer Quick Start Guide | 23
European Union Notice
Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low
Voltage Directive (73/23/EEC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European Norms (the
equivalent international standards are in parenthesis):
l EN55022 (CISPR 22)—Electromagnetic Interference
l EN55024 (IEC61000-4-2, 3, 4, 5, 6, 8, 11)—Electromagnetic Immunity
l EN61000-3-2 (IEC61000-3-2)—Power Line Harmonics
l EN61000-3-3 (IEC61000-3-3)—Power Line Flicker
l EN60950-1 (IEC60950-1)—Product Safety
Laser Compliance
This product may be provided with an optical storage device (that is, CD or DVD drive) and/or fiber
optic transceiver. Each of these devices contains a laser that is classified as a Class 1 Laser 80 Safety
and Compliance Product in accordance with US FDA regulations and the IEC 60825-1. The product
does not emit hazardous laser radiation.
WARNING: Use the controls or adjustments or performance of procedures other than
those specified herein or in the laser product’s installation guide may result in
hazardous radiation exposure. To reduce the risk of exposure to hazardous radiation:
l Do not try to open the module enclosure. There are no user-serviceable
components inside.
l Do not operate controls, make adjustments, or perform procedures to the laser
device other than those specified herein.
l Allow only HP Authorized Service technicians to repair the module.
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration
implemented regulations for laser products on August 2, 1976. These regulations apply to laser
products manufactured from August 1, 1976. Compliance is mandatory for products marketed in the
United States.
SAFETY CAUTION
The following icon or caution statements may be placed on equipment to indicate the presence of
potentially hazardous conditions:
DUAL POWER CORDS CAUTION: “THIS UNIT HAS MORE THAN ONE POWER SUPPLY
CORD. DISCONNECT ALL POWER SUPPLY CORDS TO COMPLETELY REMOVE POWER
FROM THIS UNIT.” “ATTENTION: CET APPAREIL COMPORTE PLUS D'UN CORDON
D'ALIMENTATION. DÉBRANCHER TOUS LES CORDONS D'ALIMENTATION AFIN DE
COUPER COMPLÈTEMENT L'ALIMENTATION DE CET ÉQUIPEMENT”. DIESES GERÄT
HAT MEHR ALS EIN NETZKABEL. VOR DER WARTUNG BITTE ALLE NETZKABEL AUS
DER STECKDOSE ZIEHEN.