Virtual TapeServer 8.4 Quick Start Guide

Virtual TapeServer Quick Start Guide | 25
HP NonStop S-Series Servers
Customer Installation and Servicing of Equipment
The following statements pertain to safety issues regarding customer installation and servicing of
equipment described in this manual.
l Keep door closed for normal operation.
l The equipment must be installed near the receptacles for the power cords, and the receptacles
must be easily accessible to the user.
Do not touch the DC power connector on the S7400/S7x000 PMF CRU after you have
unplugged the DC power cable from the CRU. It is possible to incur a severe energy
hazard for as long as fifteen (15) seconds after unplugging the cable. You can make
sure the CRU is safe to remove by testing (by using a volt meter) before touching the
pins on the DC power connector.
Applicability of Procedures, Instructions, and Examples
WARNING! The procedures and instructions and the examples of procedures and
instructions found in this manual apply only to the system enclosures and components
found in Himalaya S-series servers which are described in the Himalaya S-series
server documentation. Do not attempt to use these instructions with any other
Tandem NonStop system equipment. You can determine that your system is a
Himalaya S-series server by reading the label that appears inside each system
enclosure on the CRU in slot 50 or 55. The label includes the product number 1980.
Read the label before proceeding with any procedure or instruction found in this
manual.